R/C Multi-Tester
V4.33
User Manual
Power
on, you will see the main menu
- Press Select
Key to select the function, then press
> key to enter.
1.Tachometer
- Tachometer,
Select key to select number
of blades (Bs), from 2-3-4-5-1-2...go
on.
- >
to change the pitch, from 2 to 9.5 ...go on, step 0.5 inch.
- Press <
back to main menu.
- The air speed equal
RPM*60*pitch*2.54/100000.
- To measure the wind speed, take a
free run propeller, select correlative pitch, and let the propeller spin in
the wind, use tachometer to read out the air speed. the read out may less
than real speed.
¡@
2.
Digital Servo tester
Connect the servo to the tester
connecter
Power on the tester, select
"Digi Servo Tx", then press
> key to enter.
- Press Select
more than > 0.5 second, to select test mode,
Manual - knob - Fast - Middle - Slow - Random - <ESC> -
Manual... go on.
- The Knob mode is analog, others are
digital modes.
- In Knob mode, turn the potentiometer to change the
output PWM, and the servo
move consequentially.
- In manu mode, press
> key to accelerate,
< to decelerate.
- In other digital mode, press >
key to start the testing, <
to stop.
- In digital mode, press Select
key less than 0.5 second, will back to "Neutral point".
- In <ESC>
mode,
press >
key to back to main menu.
¡@
3.Speed
Controller tester
Connect tester and motor to the speed
controller to the tester connecter first, then
connect the battery.
Power on the tester, select
"Speed Ctrl Tx",
then press >
key to enter.
¡@
- Press Select
more than > 0.5 second, to select test mode, Manual - knob -
<ESC> - Manual... go on.
- The Knob mode is analog, others are
digital modes.
- In
Knob mode, turn the potentiometer to change the output PWM, and the speed
change consequentially.
- In manu mode, press
> key to accelerate,
< to decelerate.
- In digital mode, press Select
key less than 0.5 second, will back to "lowest
point".
- In <ESC>
mode,
press >
key to back to main menu.
After testing, disconnect battery first.
¡@
4.Receiver
tester
Connect
tester
and battery to receiver,
and power on the transmitter.
Power on the tester, select
"Rec_Trans Tx", then press
> key to enter.
¡@
- Read voltage and PWM width directly.
- Press <
back to main menu.
¡@
5.
Voltmeter
- You have to find out how to enter
this mode youeself, I keep this as Easter egg.
- Connect the Battery to the connecter
positive to "+", negative to ground.
BACK
======================================================================================
¡@
You MAY duplicate, modify, give away or
sell the original files in the web site or anything you derive from it.
ATTENTION : It is your own
responsibility, if any damage cause by using the web site.
Philip Sun / TAIWAN
ilufa@yahoo.com
copyright 2005
